Owner's Manual

3 Before Use the device
3.1 Removing the belt clip
Before insert batteries into the device, first remove the belt clip latch
away from the device.
3.2 Installing the Batteries and charging the device
1, Slid down the battery compartment cover.
2, Insert 3* AAA Recgargeable battery each walkie talkie
3, Position the batteries according to the polarity making on the
battery compartment.
4, After placing batteries into correct positions, replace the battery
cover.
4, When the device is low battery power, connect the USB cable to
recharge the device. The fully charging time is about 6 hours.
4 Using the device
4.1 Turning the device on/off
Switch on the device: Press and hold on the 3 seconds then you
will hear a beep sound.
Switch off the device: Press and hold on the 3 seconds then you
will hear a beep sound.
4.2 Adjusting the volume
To increase the volume, press the Up ▲ button. And press the Down
▼ button to decrease the volume.
Note: The volume level is display on the screen.
4.3 Low Battery Indication
The device can detect the low battery level when the battery voltage
goes low. When battery voltage is low, the battery icon will flash and
a beep will be heard to indicate that the batteries need to be replaced.
4.4 Receiving/transmitting communications:
The devices are in “Reception” mode when it is turned ON and no
transmitting. When a signal is received on the current channel, the
LCD will display in reception.
When you press the PTT (push to talk) button, the devices switches to
“Transmission” mode.
Hold the device in a vertical position with the Mic(microphone) 3-5cm
away from your mouth. While holding the PTT button, speak into the
microphone in a normal tone of voice.
Release the PTT button when you have finished transmitting.
For others to receive your transmission, they must be on the same
channel with you.