Owner manual

INSTRUMENTS

Model 1305

▼

Two consistently variable

0-32VDC @ 0-5AMP

outputs with coarse

and fine adjust

Constant Voltage/

Constant Current

operation with Green

LED indicators

Automatic transition

from (CV) to (CC) mode

at any voltage or current

within the range

Separate front panel

3 digit Green LEDs to

monitor Voltage or

Current from each

output

Each output is isolated,

therefore series or

parallel operation is

possible and extends

the output capabilities

to either 0-64VDC

@ 5 AMPS or 0-32VDC

@ 10AMPS

Remote sensing avail-

able on each output

Automatic overload and

short circuit protection

115-120VAC @ 60Hz or

211-220VAC @ 50Hz

operation

The 1305 DC Power Supply is a compact, high performance Dual output DC

power supply for industrial and laboratory use.

The two main outputs are continuously

variable from 0 to 32V and can supply 5A max each. they can be operated in constant voltage or constant current

modes. Automatic transition from CV to CC mode may be set at any voltage or current within the range. Separate

front panel meters are provided to monitor output voltage and load current of the variable output sections.

The output voltage and current limit settings of the variable outputs can be varied manually using front panel controls.

All outputs are floating i.e., neither the output positive terminal nor the negative terminal (nor any point within the

regular circuitry) is connected to ground.

PAGE 1
INSTRUMENTS The 1305 DC Power Supply is a compact, high performance Dual output DC power supply for industrial and laboratory use. The two main outputs are continuously variable from 0 to 32V and can supply 5A max each. they can be operated in constant voltage or constant current modes. Automatic transition from CV to CC mode may be set at any voltage or current within the range. Separate front panel meters are provided to monitor output voltage and load current of the variable output sections.
PAGE 2
▼ Two Identical Sections Output Voltage 0-32VDC continuously variable Load Current 0-5 A max. continuously variable Constant Voltage Mode Operation Line Regulation Less than ± 0.01% + 2mV (±10% line change) Load Regulation Less than ± 0.01% + 2mV (no load to full load) Ripple & Noise Less than 1mVrms max (20Hz-20MHz) Constant Current Mode Operation Line Regulation Less than ± 0.1% ± 250µA (±10% line change) Load Regulation Less than ± 0.1% + 250µA (no load to full load) Ripple & Noise 0.04% rms max (2.