User's Manual

EtherFast

Wireless Access Point + Cable/DSL Router with 4-Port Switch

Follow these instructions to install the TCP/IP Protocol on one of your PCs

only after a network card has been successfully installed inside the PC. These

instructions are for Windows 95, 98 or Milliennium. For TCP/IP setup under

Microsoft Windows NT or 2000, please refer to your Microsoft Windows NT

or 2000 manual.

1. Click the Start button. Choose Settings, then Control Panel.

2. Double-click the Network icon. Your Network window should pop up.

Select the Configuration tab.

3. Click the Add button.

4. Double-click Protocol.

5. Highlight Microsoft under the list of manufactures.

Installing the TCP/IP Protocol

2. Write down the web address returned by the ping command. (In the

example above: mail.msnv3.occa.home.com.) This web address is the web

address assigned to the IP address you just pinged. While the IP address

of “mail” could conceivably change, it is likely that this web address will

not.

3. Replace your ISP’s abbreviated server address with this extended web

address in the corresponding Internet application (web browser, e-mail

application, etc.).

Once you have replaced the brief server address with the true server address,

your Router should have no problem accessing the Internet through that

Internet application.

C:\>ping -a 24.53.32.4

Pinging mail.msnv3.occa.home.com [24.53.32.4] with 32

bytes of data:

Reply from 24.53.32.4: bytes=32 time<10ms TTL=127

Ping statistics for 24.53.32.4:

Packets: Sent = 4, Received = 4, Lost = 0 (0%

loss),

Approximate round trip times in milli-seconds:

Minimum = 0ms, Maximum = 0ms, Average = 0ms

Instant Broadband

Series