User's Manual

EtherFast

Wireless Access Point + Cable/DSL Router with 4-Port Switch

The WAN Indicators

Link Green. The Link LED illuminates when a successful con-

nection is made between the Router and your Broadband

device or network.

Act Green. The Act LED flickers when the Router is sending or

receiving data over the broadband port.

Diag Red. The Diag LED illuminates when the Router goes

through its self-diagnosis mode during boot-up and restart.

It will turn off upon successful completion of the diagnosis.

If this LED stays on for an abnormally long period of time,

refer to the Troubleshooting section.

The Wireless AP + Cable/DSL Router’s Front Panel LEDs

The LAN Indicators

WLAN Act Green. The Link LED illuminates when there is wireless

activity.

WLAN Link Green. The Link LED illuminates when the wireless option

is enabled. When the wireless option is disabled (through

the Web-based utility), the LED is off.

Power Green. The Power LED illuminates when the Router is pow-

ered on.

Link/Act Green. The Link/Act LED serves two purposes. If the LED

is continuously illuminated, the Router is successfully con-

nected to a device through the corresponding port (1, 2, 3

or 4). If the LED is flickering, the Router is actively send-

ing or receiving data over that port.

Full/Col Green. The Full/Col LED also serves two purposes. If this

LED is continuously illuminated, the connection made

through the corresponding port is successfully running in

Full Duplex mode. If the LED is flickering, the connection

is experiencing collisions. Infrequent collisions are normal.

If this LED is flickering too often, there may be a problem

with your connection. Check the Troubleshooting section if

you think there is a problem.

100 Orange. The 100 LED illuminates when a successful

100Mbps connection is made through the corresponding

port.

Instant Broadband

Series