User Manual

5
Link Quality Receiving AP link quality on infrastructure networking mode
Signal Strength Receiving AP signal strength on infrastructure networking mode
5. REGULATION COMPLIANCE
Compliant with
FCC Part 15 Class B and C
ETSI EN 300 328-2 and ETSI EN 301 489-1, -17, EN60950, CE-Mark
Telec (Japan, Customized)
WiFi Compliant
6. Environmental Requirement
6.1. Drop and Vibration
6.1.1. Anti-Static Voltage
Static voltage tests by 4 kV in card frame should not cause system fail
6.1.2. Vibration Test
The vibration test is under the frequency and amplitude 10-25 Hz 1mm in vertical and horizontal direction by 30
minutes that should not cause any damage on product.
6.1.3. Package Drop Test
Dropping the package from the height of 50cm for each of the six(6) faces onto the hard-wood floor should not cause
any damage on product.
6.2. Operation Environment
6.2.1. Temperature Range
Operating: -0 - +55 (Except RF output power and sensitivity)
Storage: -20 - +70
6.2.2. Reliability Test
One cycle of reliability test is keeping at -30 by 2 hours, switching temperature up to +60 within one hour , and
testing at +60 by 2 hours, and switching temperature to -30 within one hour. Three cycle should be tested and
without any product fail.
6.2.3. Humidity
Operating: 0% to 70%