User Manual Part 1

Manufacturer's Disclaimer Statement

The information in this document is subject to change without notice and does not

represent a commitment on the part of the vendor. No warranty or representation,

either expressed or implied, is made with respect to the quality, accuracy or fitness for

any particular purpose of this document. The manufacturer reserves the right to

make changes to the content of this document and/or the products associated with it at

any time without obligation to notify any person or organization of such changes. In

no event will the manufacturer be liable for direct, indirect, special, incidental or

consequential damages arising out of the use or inability to use this product or

documentation, even if advised of the possibility of such damages. This document

contains materials protected by copyright. All rights are reserved. No part of this

manual may be reproduced or transmitted in any form, by any means or for any

purpose without expressed written consent of its authors. Product names appearing

in this document are mentioned for identification purchases only. All trademarks,

product names or brand names appearing in this document are registered property of

their respective owners.

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class

B digital device, pursuant to Part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one of the

following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.