User Manual
15
21. You may enter “Network Address” if you would like to specify the address. By default, it is
set to “Not Present”.
21. Select “Power Mode” to indicate if you would like to select “Continuous Access Mode” to
continue to have the device on without any power saving. To select “Fast Power Save” so
the device will remain the speed of the network while perform the power saving.
“Maximum Power Save” allows the device in stand by mode and wakes whenever there’s
a signal being detected.
21. Click on “Privacy Filter” to select if you would like to “Accept All Packets” which means
the device will accept any data that is coming from the network. In “Filtering Mode” means
the device will filter out any unnecessary packets from the network.