User Manual

30
17. Select “Fragmentation Threshold” and set up a default value: 2432. The value indicates
how much of the network resources devoted to recovering packet errors. The value
should remain at its default setting of 2432 bytes. If you have decreased this value and
experience high packet error rates, you can increase it again, but will likely decrease
overall network performance.
18. You may enter “Network Address” if you would like to specify the address. By default, it is
set to “Not Present”.
19. Select “Power Mode” to indicate if you would like to select “Continuous Access Mode” to
continue to have the device on w ithout any power saving. To select “Fast Power Save” so
the device will remain the speed of the network while perform the power saving.
“Maximum Power Save” allows the device in stand by mode and wakes whenever there’s
a signal being detected.