User Manual

Federal Communications Commission Statement

This device complies with FCC Rules Part 15. Operation is subject to the following two conditions:

This device may not cause harmful interference.

This device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part

15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in

a residential installation. This equipment generates, uses and can radiate radio frequency energy. If this

equipment is not installed and used in accordance with the manufacturer's instructions, it may cause harmful

interference to radio communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or television reception, which

can be determined by during the equipment off and on, the user is encouraged to try to correct the interference by

one or more of the following measures:

--Reorient or relocate the receiving antenna.

--Increase the separation between the equipment and receiver.

--Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.

--Consult the dealer or an experienced radio/TV technician for help.

The use of shielded cables for connection of the monitor to the graphics card is required to assure compliance with

FCC regulations. Changes or modifications to this unit not expressly approved by the party responsible for

compliance could void the user's authority to operate this equipment.

---This device includes an module which can emit RF energy.For compliance with FCC RF exposure rule,the user

has to keep at least 20cm separation distance between the radiator and the body of the user.

---This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Manufacturer's Disclaimer Statement

The information in this document is subject to change without notice and does not represent a commitment on the

part of the vendor. No warranty or representation, either expressed or implied, is made with respect to the

quality, accuracy or fitness for any particular purpose of this document. The manufacturer reserves the right to

make changes to the content of this document and/or the products associated with it at any time without obligation

to notify any person or organization of such changes. In no event will the manufacturer be liable for direct,

indirect, special, incidental or consequential damages arising out of the use or inability to use this product or

documentation, even if advised of the possibility of such damages. This document contains materials protected

by copyright. All rights are reserved. No part of this manual may be reproduced or transmitted in any form, by

any means or for any purpose without expressed written consent of its authors. Product names appearing in this

document are mentioned for identification purchases only. All trademarks, product names or brand names

appearing in this document are registered property of their respective owners.

Printed in Taiwan