User's Manual

GL-2454MU-0I
Quick Installation Guide
Access Point. In Ad Hoc mode, the channel must be manually set to the same channel
for each wireless adapter
Tx Rate:
You can adjust the transmission rate to get the best signal possible depending
on your usage and your environment. The Tx Rate will be determined
automatically by signal strength. Default is set to Auto.
Preamble:
Select Long or Short Preamble. The Preamble defines the length of the
CRC block (Cyclic Redundancy Check is a common technique for detecting data
transmission errors) for communication between the Access Point and the roaming
wireless Network adapters
Power Mode: Select from three modes:
Continuous Access Mode - this default setting consumes the most power
Maximum Power Save - this setting consumes the least power
Power Save - this setting consumes a moderate amount of power
4.3 Encryption
Data Encryption:
Enable encryption by clicking in the box. Data encryption is de-selected as the default
setting.
Default Key
:
Enter a key in either ASCII (e.g., a word) or hexadecimal format. Select one of
the 4 keys that you have created to be the default key.
Authorization Mode:
Click Apply if you have made any changes
Open Authentication - communicates the key across the network
Shared Authentication - allows communication only with other devices
with identical WEP settings
Auto - will automatically adjust to the Authentication mode of the wireless
Access Point or Router
4.4 Site Survey
Available Networks: