User's Manual

6.3.3 Switching the headset from a paired device to the other
The headset can only receive an incoming call from only one device at a time,
no matter one or two devices it is paired with. However, you can set up the
priority of receiving 2 devices’ incoming calls.
 If the headset has been paired with 2 devices, you need to remember
which device you paired with by volume up button, and the other by
volume down button. The headset use volume up and volume down
buttons to manage 2 pairing devices.
 Select the high priority pairing device you prefer, and press the volume up
or volume down button (depend on the button when you set up pairing
devices) around 2 seconds, until you hear a long beep tune, release the
button, then Function LED will fresh GREEN every 5 seconds. This
means the headset has been switched to the 1
st
priority pairing device and
auto connected.
 If the headset is only paired with one device, even though you press
volume up or volume down button try to switch the priority, the headset still
remain the only paired device as 1
st
priority.
 The priority setting will remain internally of the headset and keep the
setting until you try to clear pairings or reset priority again. It won’t lose
priority setting when you turn off the headset.
6.4 Answering incoming calls
When a call is forwarded from a pairing device to the headset, the headset
rings as well. Press any button to answer a call.
6.5 Speaker Volume control
 Press “+” to volume up
 Press “-“ to volume down
6.6 End a call
After you finish a call, press call handling button (Θ) to finish a call. You need
always to press call handling button (Θ) to release a call, otherwise, the
headset will remain the connection with the pairing device.
7