User Manual

Function Matrix
Function Pick Up Hang Up Volume+ Volume- State
Power On ++ Power Off
Power Off ++ Power On
Pick Up + Receive Calling
Hang Up + During Communication
Volume+ + During Communication
Volume- + During Communication
Voice Dialing + Standby
Last Call Redial v v Standby
Pairing +++ Power Off
Transfer(Mobile Phone & Car kit) ++ During Communication
Mute ++ During Communication
Cancel Mute ++ During Communication
Refuse Answering ++ Receive Calling
Restore Factory settings ++ ++ Standby
「Short Click: “＋”」 ：Clip and release less than 1 second
「Long Press: “＋＋”」 ：Press and release for 2 seconds
「Double Click: “v v”」 ：Click twice within 0.5 second
「Press and Hold: “＋＋＋”」 ：Press and hold the key for more than 6 seconds
5.
Certification and Safety Approvals/General Information
1. The device is CE、FCC and E-mark approved.
2. Federal Communication Commission(FCC) Statement：
a. Rule15.21：You are cautioned that changes or modifications not expressly approved by the part
responsible for compliance could void the user’s authority to operate the equipment.
b. Rule15.105（b）：This equipment has been tested and found to comply with limits for a Class
B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help.