User Manual

iTooth 2
11/17/2008
1.4 Product Outlook：
2 Indications： Blue（B）
2.1 Pairing ：（B）Blink rapidly
2.2 Stand by ：（B）Blink once per 5 seconds
2.3 Streaming ：（B）Breathy indication
3 Prepare to use the product
3.1 Turn On: Connect iTooth to iPod via iPod connector underneath, click the button on the iTooth and
blue indication will start blinking.
3.2 Turn Off: iTooth will be power-off whenever iPod been turned off.
3.3 Pair and connect to new Bluetooth receiver(s)
A pairing procedure with the aim Bluetooth audio receiver will be requested to establish a
Bluetooth connection at the very first usage:
a. Plug iTooth with iPod.
b. Turn your aim Bluetooth audio receiver on and enter to the pairing mode.
c. Short click the iTooth button (Blue indicator begins to blink rapidly), to the pairing mode, iTooth
will automatically scan and connect to the new device nearby.
d. Repeat the above procedures to complete the second pairing with second receiver, now
iTooth will stream the stereo audio to dual Bluetooth receiver simultaneously.
e. Whenever iTooth connected the Bluetooth receiver the breathy indication will be seen, and it
will automatically send the “play”
instructions to iPod to stream the music wirelessly. If only
one receiver has been found, please click the button to pick up the second receiver. Or long
press the button to enter to the pairing mode.
Note: iTooth supports A2DP and AVRCP Dual Air™ stream simultaneously, which means both receivers
connected to iTooth could process Bluetooth remote control function.
Note: Whenever iTooth connected the Bluetooth receiver, it will automatically send the “play”
instructions to
iPod to stream the music wirelessly.