User Guide
Table Of Contents
- Package contents
- Product overview
- Connecting the base station
- Connecting the base station to the mains power supply
- Pairing and charging the headset before first use
- Connecting the base station to a fixed line phone – SDW 5 BS only
- Connecting the base station to a computer
- Connecting the base station to Bluetooth devices – BTD 800 USB only
- Reconnecting/disconnecting Bluetooth
- Connecting an optional USB headset or speakerphone
- Connecting an optional busy light
- Assembling and wearing the headset SDW 10 HS
- Adjusting and wearing the headset SDW 30 HS | SDW 60 HS
- Labeling the headset
- Configuring the headset system
- Setting up and using the headset
- Making calls using the headset system
- Preparing calls - initial settings
- Selecting audio source – fixed line phone/ computer/ mobile phone
- Making a call
- Accepting/rejecting a call
- Transferring calls to connected devices
- Ending a call
- Redialing
- Putting a single active call on hold
- Managing multiple calls - two calls from two audio sources
- Setting up conference call
- Using the dictation mode
- Listening to music using the headset
- Using the motion sensor
- Charging the headset and storing the headset system
- Sharing a workplace
- Cleaning and maintaining the headset system
- If a problem occurs ...
- Specifications
SDW 5000 series headset system
CONNECTING THE BASE STATION10
Connecting the base station to the mains power supply
1
2
Connect the plug of the power supply unit to the
DC socket (marked yellow).
Connect the power supply unit to a wall socket.
The LED lights up red.
See page 13 for supported features with and without
power supply connection.
Disconnecting the base station from the mains power supply
Unplug the power supply unit from the wall socket, if the product is not used for extended periods of time.
Pairing and charging the headset before first use
Charge the rechargeable battery for at least 20 minutes before using it for the first time.
A complete charging process takes about 60 minutes for SDW 10 HS and 90 minutes for SDW 30 HS/ SDW 60 HS
(see page 46).
1
2
3x
Place the headset into the magnetic holder of the base
station.
The Headset battery status LEDs on the base station
indicate the charge status.
If the headset and base station are not paired, the
headset LED flashes blue and red shortly. The LED turns
blue when pairing is complete and the headset will start
charging.
SDW 10 HS SDW 30 HS SDW 60 HS
During the first charging process and after long periods of non-use, it may take up to 5 minutes until the headset
LED lights up.
i