User Guide
Table Of Contents
- Package contents
- Product overview
- Connecting the base station
- Connecting the base station to the mains power supply
- Pairing and charging the headset before first use
- Connecting the base station to a fixed line phone – SDW 5 BS only
- Connecting the base station to a computer
- Connecting the base station to Bluetooth devices – BTD 800 USB only
- Reconnecting/disconnecting Bluetooth
- Connecting an optional USB headset or speakerphone
- Connecting an optional busy light
- Assembling and wearing the headset SDW 10 HS
- Adjusting and wearing the headset SDW 30 HS | SDW 60 HS
- Labeling the headset
- Configuring the headset system
- Setting up and using the headset
- Making calls using the headset system
- Preparing calls - initial settings
- Selecting audio source – fixed line phone/ computer/ mobile phone
- Making a call
- Accepting/rejecting a call
- Transferring calls to connected devices
- Ending a call
- Redialing
- Putting a single active call on hold
- Managing multiple calls - two calls from two audio sources
- Setting up conference call
- Using the dictation mode
- Listening to music using the headset
- Using the motion sensor
- Charging the headset and storing the headset system
- Sharing a workplace
- Cleaning and maintaining the headset system
- If a problem occurs ...
- Specifications
SDW 5000 series headset system
CONNECTING THE BASE STATION16
Pairing a headset via Bluetooth
1
<20 cm
2
Press & hold
3s
”Pairing“
Activate the pairing mode on your Bluetooth headset
(see the instruction manual of your device).
Press and hold the dongle’s button for 3 seconds to
enter pairing mode.
The LED alternately flashes blue and red.
3
A
B
1s 1s 1s 1s
0.5s 0.5s 0.5s 0.5s
4
”Connected“
3x
Press the button again to switch between pairing mode
for mobile phones A or headsets B.
Once the Bluetooth devices are paired, the LED flashes
3 times blue and then lights up in a constant dim blue.
Clearing the list of previously paired devices
Press and hold the dongle’s button for 3 seconds to enter pairing mode.
The LED alternately flashes blue and red.
Double press the dongle’s button.
The LED flashes purple three times. The pairing list is cleared.
Reconnecting/disconnecting Bluetooth
3x
2x
3x
To reconnect a Bluetooth device:
Tap the dongle’s button.
The LED lights up blue once and after that flashes
3 times blue. The LED is lit constantly in dim blue.
To disconnect a Bluetooth device:
Double tap the dongle’s button.
Bluetooth will be disconnected. The LED flashes
3 times red. The dongle starts flashing blue and
searches for other Bluetooth devices.