Global7243A LTE Window CPE Quick User Guide V1.
PLEASE READ THESE SAFETY PRECAUTIONS! RF Energy Health Hazard The radio equipment described in this guide uses radio frequency transmitters. Although the power level is low, the concentrated energy from a directional antenna may pose a health hazard. Do not allow people to come in close proximity to the front of the antenna while the transmitter is operating.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. The transmitter must not be colocated or operated in conjunction with any other antenna or transmitter. This equipment complies with the FCC RF radiation exposure limits set forth for an uncontrolled environment.
1. Overview The Global7243A is highly innovative and patented LTE window mounted CPE product designed to enable quick and easy LTE fixed data service deployment for residential and SOHO customers. It provides high speed LAN services to end users who need both bandwidth and multi-media data service in enterprise or home. It can also be used to support wireless fall back service. 1.1.
2. Getting Started 2.1. Packing list and CPE Unit Upon receiving the product, please unpack the product package carefully. Each product is shipped with the following items: Table 2-1 Packing List Products WDU Unit Quantity 1 ETH cable 2.0M 1 PoE Adapter 1 Power cord 1.5M 1 Quick user guide 1 If you find any of the items missed, please contact your local distributor immediately. 2.2. Installing the Equipment Open the cover, insert the SIM card and connected the ETH cable.
Mounting Bracket Using screws to fixed. Using a suction cup to fixed. Use stickers to fixed.
Install the device to the bracket.
LED Display LED Function SYS System run indicator SIM SIM card indicator Light is on – SIM card state is ready, Blinking Green – SIM card is error. ETH LAN port status Solid Green – LAN port is up. Blinking Green –LAN port in working. RF (5LEDs) RF Signal Strength Description Solid green – Device is in normal operation. 5 level signal strengths indication by 5 green LEDs.
3.2 System configuration Network Information This page is showing the device network information and the user can change the network interface config. Maintenance This page allows user to update the device firmware version, rest the device to factory setting and reboot the device.
3.3 LTE configuration LTE Information This page showing the LTE information. LTE Setting This page allows user to configure the LTE setting.
SIM PIN The SIM card menu is used to view the SIM card status. OMA-DM This page allows user to LTE FOTA test.
4. Troubleshooting Q1: My PC cannot connect to the CPE. Check the PoE adapter LED is on and your PC LAN port is working. Q2: My CPE networking is not working properly. Check and make sure you are within LTE coverage. Q3: Unable to connect internet while the device is already connected to LTE network. Check and verify your computer has the ETH adapter installed and enabled. Unplug the PC Lan port and reconnect again if required.
