User's Guide

List of applicable FCC rules
FCC Part 22; FCC Part 24E; FCC Part 27
Specific operational use conditions
This product is a Limited Single Modular transmitter; the module may be operated only with
the antenna with which it is authorized. Any antenna that is of the same type and of equal
or less directional gain as an antenna that is authorized with the intentional radiator may
be marketed with, and used with, that intentional radiator.
Limited module procedures
Global Telecom Corp will retain control over the final installation of the modular such that
compliance of the end product is assured. In such cases, an operating condition on the
limit modular approval for the module must be only approved for use when installed in
devices produced by a specific manufacturer. If any hardware modify or RF control
software modify will be made by host manufacturer. C2PC or new certificate should be
apply to get approval, if those change and modification made by host manufacturer not
expressly approved by the party responsible for compliance, then it is illegal.
Trace antenna designs
This product has four External Antennas. Not applicable.
RF exposure considerations
This equipment complies with the FCC RF radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with a
minimum distance of 20cm between the radiator and any part of your body.
Antennas
This module is for use with external antennas only, and the antenna is recommended as
below:
No. Antenna Type Model
Frequency
Range(MHz)
Gain
1 PCB antenna 33V_ANT_F07F38
1850-1910MHz 4dBi
1710-1755MHz 5dBi
824-849MHz 2dBi
699-716MHz 2dBi
777-787MHz 2dBi
704-716MHz 2dBi
1850-1915MHz 4dBi
814-849MHz 2dBi
2496-2690MHz 4dBi
1710-1780MHz 4dBi
663-698MHz 1dBi
Label and compliance information
FCC ID label on the final system must be labeled with “Contains FCC ID: S3KG7243A4CB”
or “Contains transmitter module FCC ID: S3KG7243A4CB”.