User’s Manual 3307568 Version 1.
3307568 User’s Manual Copyrights This manual is copyrighted and all rights are reserved. It does not allow any non authorization in copied, photocopied, translated or reproduced to any electronic or machine readable form in whole or in part without prior written consent from the manufacturer.
307568 User’s Manual Packing List Please check package component before you use our products.
3307568 User’s Manual Index Chapter1 ............................................................ 7 1.1 .............................................................................................7 1.2 ........................................................................................8 1.3 ................................................................................................10 1.4 ...............
3307568 User’s Manual Chapter 3 ....................................... 36 3.1 ..........................................................................................36 3.2 ...............................................................................37 3.3
3307568 User’s Manual (This Page is Left for Blank) 6
3307568 User’s Manual Introduction Chapter1 1.1 3307568 is the Full-size single board computer with last Intel desktop technology with PICMG form factor. Based on Intel Q965 and ICH8DO, the board integrates a new Core 2 Duo processor 775-pin socket, DDR2 memory socket, Intel Graphic Media Accelerator 3000 technology, Serial ATA II with RAID function for a powerful desktop system.
3307568 User’s Manual Introduction 1.
3307568 User’s Manual Introduction Ethernet Interface Controller Type Connector One or two Intel 82573L Gigabit Ethernet controller Triple speed 10/100/1000Base-T Auto-switching Fast Ethernet Full duplex, IEEE802.
3307568 User’s Manual Introduction 1.3 Intel Core 2 Duo with 775 pin PLGA processor DVI CH7307 LVDS CH7308 Intel Q965 2 x 240-pin DDR2 533/667/800MHz up to 3GB 6 x Serial ATAII ports 6 x USB2.
3307568 User’s Manual Introduction 1.
3307568 User’s Manual Hardware Setup Chapter 2 2.
3307568 User’s Manual Hardware Setup 2.
3307568 User’s Manual Hardware Setup 2.3 2.3.
3307568 User’s Manual Hardware Setup 2.4 2.4.1 3307568 has a LGA775 CPU socket onboard; please check following steps to install the processor properly. Attention If 3307568 need RMA please Keep CPU socket cover on the CPU Socket. Warring If CPU Socket internal Pin damage We could not provide warranty.
3307568 User’s Manual Hardware Setup 2.4.2 3307568 has two 240-pin DDR2 DIMM support up to 3GB of memory capacity. The memory frequency supports 533/667/800MHz . Only Non-ECC memory is supported. DDRIIA/B 128-pin 112-pin Please check the pin number to match the socket side well before installing memory module.
3307568 User’s Manual Hardware Setup 2.5 The board’s data of CMOS can be setting in BIOS. If the board refuses to boot due to inappropriate CMOS settings, here is how to proceed to clear (reset) the CMOS to its default values.
3307568 User’s Manual Hardware Setup 2.6 3307568 has six Serial ATA II interfaces with RAID function, the transfer rate of the Serial ATA II can be up to 300MB/s. Please go to http://www.serialata.org/ for more about Serial ATA technology information. Based on Intel ICH8DO, it supports Intel Matrix Storage Technology with combination of RAID 0,1,5 and 10. The main features of RAID on ICH8DO are listed below: 1.
3307568 User’s Manual Hardware Setup 2.7 The Intel 82573L supports triple speed of 10/100/1000Base-T, with IEEE802.3 compliance and Wake-On-LAN supported.
3307568 User’s Manual Hardware Setup 2.8 Based on Intel Q965 chipset with built-in graphics, the board provides one DB15 connector on real external I/O port, and one 40-pin LVDS interface with 5-pin LCD backlight inverter connector. (3307568C & D Only) The board also provides 26-pin DVI interface. (3307568A & B Only ) 2.8.1 Please connect your CRT or LCD monitor with DB15 male connector to the onboard DB15 female connector on bracket.
3307568 User’s Manual Hardware Setup 2.8.2 The board provides one 40-pin LVDS connector for 18/24-bit dual channel panels, supports up to 1600 x 1200 (UXGA) of resolution, with one LCD backlight inverter connector and one jumper for panel voltage setting.
3307568 User’s Manual Hardware Setup Connector: CN_INV Connector: JVLCD Type: 5-pin LVDS Power Header Type: 3-pin Power select Header Connector model: JST B5B-XH-A Pin Description Pin 1 +12V 1 VCC (5V) 2 GND 2 LCDVCC 3 GND 3 VCC3 (3.3) 4 GND 5 ENABKL Connector: CN_LVDS Type: onboard 40-pin connector for LVDS connector Connector model: HIROSE DF13-40DP-1.
3307568 User’s Manual Hardware Setup To setup the LCD, you need the component below: 1. A panel with LVDS interfaces. 2. An inverter for panel’s backlight power. 3. A LCD cable and an inverter cable. For the cables, please follow the pin assignment of the connector to make a cable, because every panel has its own pin assignment, so we do not provide a standard cable; please find a local cable manufacture to make cables. LCD Installation Guide: 1.
3307568 User’s Manual Hardware Setup After setup the devices well, you need to select the LCD panel type in the BIOS. The LCD type mapping is list below: BIOS panel type selection form Single channel Dual channel NO. Output format NO.
3307568 User’s Manual Hardware Setup 2.8.3 The board provides optional DVI-D interface with Intel Q965, compliant with DVI 1.0 standard. Connector: CN_DVI Connector type: 26-pin header connector (pitch = 2.
3307568 User’s Manual Hardware Setup 2.9
3307568 User’s Manual Connector: CN_AUDIO Type: 10-pin (2 x 5) header (pitch = 2.54mm) Pin Description Pin 1 MIC_L 2 3 MIC_R 4 5 Speaker_R 6 7 SENSE 8 9 Speaker_L 10 Hardware Setup Description Ground ACZ_DET MIC Detect N/C Speaker Detect Connector: CDIN Type: 4-pin header (pitch = 2.
3307568 User’s Manual Hardware Setup 2.11 The board provides a programmable 8-bit digital I/O interface for control panel application. Connector: CN_DIO Type: onboard 2 x 6-pin header, pitch=2.
3307568 User’s Manual Hardware Setup 2.12 Based on Intel ICH8HDO , the board provides 6 USB2.0 ports. The USB2.0 interface provides up to 480Mbps of transferring rate. The Intel ICH8DO contains two Enhanced Host Controller Interface (EHCI) and five Universal Host Controller Interfaces (UHCI), it can determine whether your connected device is for USB1.1 or USB2.0, and change the transfer rate automatically.
3307568 User’s Manual Hardware Setup 2.13 The 3307568 provides a standard ATX power supply with 4-pin ATX connector and 8-pin additional 12V connector, and the board provides one 4-pin fan connector supporting smart fan for CPU cooler and two 3-pin cooler fan connectors for system and Northbridge chip. The 8-pin CN_12V additional power connector is necessary for CPU powering; please connect this well before you finishing the system setup.
3307568 User’s Manual Hardware Setup Connector: CN_12V Type: 8-pin ATX power connector PIN assignment 1 GND 2 GND 3 GND 4 GND 5 6 7 8 +12V +12V +12V +12V Connector: DC_IN Type: 4-pin P-type connector for +5V/+12V input Pin Description Pin Description Pin Description 1 +12V 2 Ground 3 Ground Connector: CN_PS Type: 3-pin ATX function connector Pin Description Pin 1 5V Standby 2 Connector: CPUFAN Type: 4-pin fan wafer connector Pin Description 1 Ground 3 Fan Speed Detection Connector: NBFAN, SYSFAN Type:
3307568 User’s Manual Hardware Setup 2.14 The board supports one RS232 serial port and one jumper selectable RS232/422/485 serial ports. The jumper JCSEL1 & JCSEL2 can let you configure the communicating modes for COM2. Connector: CN_COM1/2 Type: 10-pin (5 x 2) 2.54mm x 2.
07568 User’s Manual Hardware Setup JCSEL1 JCSEL2 2 12 2 8 1 11 1 7 SIR RS-422 RS-485 RS-232 Serial Port 33
3307568 User’s Manual Hardware Setup 2.15 The JFRNT provides front control panel of the board, such as power button, reset and beeper, etc. Please check well before you connecting the cables on the chassis. Connector: JFRNT Type: onboard 14-pin (2 x 7) 2.
3307568 User’s Manual (This Page is Left for Blank) 35
3307568 User’s Manual System Configuration Chapter 3 3.1 SATA Mode: This option can let you select whether the Serial ATA hard drives would work under normal IDE mode or RAID mode. The RAID mode need more than one HDD is applied.
3307568 User’s Manual System Configuration 3.2 The board integrates Intel ICH8DO with RAID function for Serial ATA II drives, and supports the configurations below: RAID 0 (Stripping): Two hard drives operating as one drive for optimized data R/W performance. It needs two unused drives to build this operation.
3307568 User’s Manual System Configuration Please press to enter the RAID configuration menu. You can setup the RAID under operation system for Microsoft Windows XP SP1 or Windows 2000 SP4 version, please install the Intel Application Accelerator Ver.4.5 later to support RAID configuration with Intel Matrix Storage Technology. 1. After installing Intel Application Accelerator, please execute Intel Storage Utility.
3307568 User’s Manual System Configuration 2.
3307568 User’s Manual System Configuration 3. Please select two hard drives to prepare to set the RAID volume 4. Specify the Volume size Tune this bar to specify the volume size, if you specify the volume size lower than maximum, you can create a second volume for another RAID set. (Make RAID 0+1 on only two hard drives) 5. Repeat the step 1 to create second volume as RAID Level 1. For other configuration set please click Help on tool bar.
3307568 User’s Manual System Configuration 3.3
3307568 User’s Manual System Configuration 3.4
3307568 User’s Manual System Configuration Fixed + DVMT Memory Size: You can select the fixed amount and the DVMT amount at the same time for a guaranteed video memory and additional dynamic video memory, please check the table below for available setting.
3307568 User’s Manual System Configuration 3.5 Based on Intel Q965 GMCH with GMA3000 (Graphic Media Accelerator), the board supports two DACs for display device as different resolution and color bit. Please install the Intel Graphic Driver before you starting setup display devices. 1. Click right button on the desktop to lunch display properties 2. Click Advanced button for more specificity setup. Click Graphics Properties...
3307568 User’s Manual System Configuration 3. This setup options can let you define each device settings.
3307568 User’s Manual BIOS Setup Chapter 4 The motherboard uses the Award BIOS for the system configuration. The Award BIOS in the single board computer is a customized version of the industrial standard BIOS for IBM PC AT-compatible computers. It supports Intel x86 and compatible CPU architecture based processors and computers. The BIOS provides critical low-level support for the system central processing, memory and I/O sub-systems.
3307568 User’s Manual (This Page is Left for Blank) 47
3307568 User’s Manual I/O Port Pin Assignment Appendix A A.1 1 7 Connector: S_ATA1/2/3/4/5/6 Type: 7-pin wafer connector 1 2 3 4 5 6 7 GND RSATA_TXP1 RSATA_TXN1 GND RSATA_RXN1 RSATA_RXP1 GND A.
3307568 User’s Manual I/O Port Pin Assignment A.3 6 1 2 3 4 5 Connector: CRT Type: 15-pin D-sub female connector on bracket 11 12 13 14 15 10 1 2 3 4 5 Description RED GREEN BLUE N/C Ground Pin 6 7 8 9 10 Description Ground Ground Ground +5V Ground Pin 11 12 13 14 15 Description N/C DDC_DA HSYNC VSYNC DDC_CLK A.
3307568 User’s Manual System Resources Appedix B B1.
307568 User’s Manual I/O Port Address Map System Resources 51
3307568 User’s Manual System Resources B2.
3307568 User’s Manual System Resources B3.
3307568 User’s Manual Appedix C C.1 BIOS Auto Flash Tool The board is based on Award BIOS and can be updated easily by the BIOS auto flash tool. You can download the tool online at the address below: http://www.award.com TU UT File name of the tool is “awdflash.exe”, it’s the utility that can write the data into the BIOS flash ship and update the BIOS. C.2 Flash Method 1. Please make a bootable floppy disk. 2. Get the last .bin files you want to update and copy it into the disk. 3.
3307568 User’s Manual Appendix D The GPIO’can be programmed with the MSDOS debug program using simple IN/OUT commands.The following lines show an example how to do this. GPIO0…..
3307568 User’s Manual Appendix E The watchdog timer makes the system auto-reset while it stops to work for a period. The integrated watchdog timer can be setup as system reset mode by program.
3307568 User’s Manual Contact Information Any advice or comments about our products and service, or anything we can help you with please don’t hesitate to contact with us. We will do our best to support you for your products, projects and business. Global American Inc. Contact Information Address: 17 Hampshire Drive Hudson, NH 03051 TEL: Toll Free (U.S. Only) 800-833-8999 (603)886-3900 FAX: (603)886-4545 Website: http://www.globalamericaninc.com E-Mail: salesinfo@globalamericaninc.