Instructions / Assembly

10
Support videos are available at: https://bluline.com/support/
Drain Connection
The drain connection applies to models with Reverse Osmosis, “RO.”
The Reverse Osmosis Filter will push the water through the line to the
drain. It does not need to be higher than the drain.
The black drain line in the back (Figure 4) must be hooked to the
drain line ahead of the normal sink water trap.
See Figure 5 below. Place the two-part drain saddle on the drain pipe
before the drain trap. Allow proper space for the drilling operation.
Tighten the saddle bolts evenly on both sides. Using the opening in the
drain outlet saddle as a guide, drill a one-quarter inch (1/4) hole in the
drain pipe. Clean any debris out of the drain saddle connection. Connect
the drain line to the cooler using the 1/4” black tubing supplied.
CAUTION: We have supplied parts to connect to a drain. The process described
and the parts supplied may not comply with your local building codes and
ordinances. Some local codes require the use of an air gap. It is the installer’s
responsibility to ensure the installation is in compliance with local codes.
Figure 4. Drain Connections for “RO” models