Instructions / Assembly

Support videos are available at: https://bluline.com/support/

Tank Flush

Flush tanks flush by draining all water through the drain plug

located on the back of the cooler. The tanks drain water through the

dispensing spigots. Fill and empty the tanks three times with the filtered

water. This ensures great tasting water. When the tank has filled again

with filtered water, the cooler is ready to dispense water. You may now

turn on the Hot and Cold buttons on the back of the machine. Remember,

you should always turn on the Hot and Cold elements when they have

water inside the tanks.

CAUTION. DO NOT TURN ON HOT OR COLD POWER CONTROLS YET.

Remove the top cover of the cooler by removing two screws from the back

of the top cover. Pull the cover off, exposing the main tank. This model

uses an electric float valve to control flow to the tank. The unit does have

to be plugged in to start water flow.

Water will flow into the cold tank and then the hot tank as well. Let cooler

tanks fill with the filtered water until full. It takes about one hour for the

‘RO’ version, and between 10 to 15 minutes for the ‘F’ version.

Observe the water level when full and see that the water input to the tank

stops when it is full.

Figure. 6 Back view of the Cooler Water Connections Model G3