Instructions / Assembly

Support videos are available at: https://bluline.com/support/

Filter Replacement

The filter elements must be replaced at regular intervals to maintain the

quality of the water.

better tasting water.

For more information please visit:

https://bluline.com/filter-replacements

The G3F has three stages of mechanical filtration. The first stage is the

5-micron sediment filter. The second stage is the activated carbon filter.

The third stage is the post carbon filter. The filter elements in all stages

must be replaced every six months.

The G3RO model has the three stages of filtration plus an additional

Reverse Osmosis membrane filter.

The two pre-filters and 1 post filter must be replaced every six months.

The Reverse Osmosis membrane must be replaced every three years.

Replacement Procedures, Filtration Versions (F)

a) TURN OFF POWER TO HOT/COLD ELEMENTS.

b) Swing open the front hinged cover.

c) Close the ball valve to stop water flow through the filters.

d) Place a towel under the filters to catch water. The filters will have

water in them which will run out when the filters are unlocked.

e) Twist the filters to remove them from their housings.

f) These filters are disposable, encapsulated filters. Remove and

discard the entire filter body. Replacement filters are sold as a set:

1st Stage sediment filter

2nd Stage carbon filter P/N ETSET

Stage post carbon

f) Twist new filters on the housing brackets.

g) Open ball valve and let water flow through filters. When the cooler

is full, empty out the water into a bucket. This will eliminate the

first batch of water, which is full of carbon fines.

h) After the cooler fills up again, turn on the power to the cold and hot

tanks. Wait a few minutes to assure there are no leaks and close the

filter door.