Instructions / Assembly

4
Support videos are available at: https://bluline.com/support/
Receiving the Cooler
Unpacking
Global Water products are shipped completely assembled and
ready to operate. Remove the top of the box and slide the water cooler
out and save the box and packing materials.
Inspection
Inspect the cooler for shipping damage. Look at the exterior panels
to see if they have been dented or damaged. Check the dispensing spigots
in the front. Open the bottom panel to assure that the filter system is in
tact. Look at the back of the cooler to see if the compressor is secure and
has not broken from the mounting. Inspect the filter system to see that
nothing is damaged or dislodged from shipping.
Description Model G3
The G3 provides water at two temperatures. The water is dispensed
from two spigots—one “hot” and one “cold.” The assembly drawing is
shown in Figure 1 for the G3. Water flows from the filter system into the
top tank, also known as the cold water tank. This tank then feeds the hot
tank that is heated by internal heaters. The level in the cold water tank is
controlled by a float valve mechanism. This mechanism shuts off the flow
of filtered water when both tanks are full.
The water production flow chart is shown in Figure 2.