Instructions / Assembly

12
Support videos are available at: https://bluline.com/support/
Start-Up Flush
Open lower front door to access filter assembly. Then, turn the water
on at the at the water connection. This brings water to the ball valve.
Disconnect the tube from the second stage carbon filter (red circle in figure
bellow), and place a cup or pan right underneath the hole to catch water.
Open ball valve inside the cooler 1/4-turn. The handle in line with the tube is
“on.” Let water flow through filters into the bucket or pan to push out air and
carbon fines. When water runs clear, turn off the ball valve and re-connect
the tube to the filter.
Turn the water on to the filter system by opening the ball valve inside the
cooler 1/4-turn (handle in line with tube is “on”). Check all connections to
assure there are no leaks.
VIDEOS ARE AVAILABLE AT: https://bluline.com/support/
Figure.5 Filter configuration model “F” with cooler door opened.