Use and Care Manual

10 | P a g e
Drain Connection
The drain connection applies to models with Reverse Osmosis, “RO.”
The black drain line in the back (Figure 4) must be hooked to the
drain line ahead of the normal sink water trap.
See Figure 5 below. Place the two-part drain saddle on the drain pipe
before the drain trap. Allow proper space for the drilling operation.
Tighten the saddle bolts evenly on both sides. Using the opening in the
drain outlet saddle as a guide, drill a one-quarter inch (1/4) hole in the
drain pipe. Clean any debris out of the drain saddle connection. Connect
the drain line to the cooler using the 1/4” black tubing supplied.
**The drain water will continue to run out of the back of the cooler
until the unit is full of water, then it will shut off**
Figure 5. Drain Connections for “RO” models