Use and Care Manual

4 | P a g e
Receiving the Cooler
Unpacking
Global Water products are shipped completely assembled and ready to
operate. Remove the top of the box and slide the water cooler out and save
the box and packing materials.
Inspection
Inspect the cooler for shipping damage. Look at the exterior panels to see if
they have been dented or damaged. Check the dispensing spigots in the
front. Open the bottom panel to assure that the filter system is in tact. Look
at the back of the cooler to see if the compressor is secure and has not
broken from the mounting. Inspect the filter system to see that nothing is
damaged or dislodged from shipping.
Description G4 Counter Top
The G4 provides water at two temperatures. The water is dispensed from
two spigots—one “hot” and one “cold.” The assembly drawing is shown in
Figure 1 for the G3 and Figure 2 for the G4. Water flows from the filter
system into the top tank, also known as the cold water tank. This tank then
feeds the hot tank that is heated by internal heaters. The level in the cold
water tank is controlled by a float valve mechanism. This mechanism
controls a solenoid valve on the water feed line to maintain a constant level
of filtered water. Both models are available with reverse osmosis (RO) or
standard filter (F) versions.
The water production flow chart is shown in Figure 3.