Use and Care Manual

13 | P a g e
Drain Connection
(Applies to models with Reverse Osmosis “RO” only)
The drain line in the back (Fig. 4) must be hooked to the drain
line ahead of the normal sink water trap.
See Figure 5 below. Place the 2 part drain saddle on the drain pipe
before the drain trap. Allow proper space for the drilling operation.
Tighten the saddle bolts evenly on both sides. Using the opening in the
drain outlet saddle as a guide, drill a 1/4” hole in the drain pipe. Clean
any debris out of the drain saddle connection. Connect the drain line
to the cooler using the 1/4” black tubing supplied.
Figure 5. Drain Connections for “RO” models