Instructions / Assembly
Support videos are available at: https://bluline.com/support/
16
Tank Flush
Flush tanks out by draining all water through the (1) drain plug
located on the back of the cooler and drain water through the dispensing
spigots. Fill and empty the tanks 3 times with the filtered water, this
ensures great tasting water. When the tank has filled again with filtered
water the cooler is ready to dispense water. You may now turn on the
Hot and Cold buttons on the back of the machine. NOTE: You should
always turn on the Hot and Cold elements when they have water inside
the tanks.
CAUTION. DO NOT TURN ON HOT OR COLD POWER CONTROLS YET.
Remove the top cover of the cooler by removing 2 screws from back of
top cover. Pull the cover off, exposing the main tank. This model uses a
mechanical float valve to control flow to the tank. The unit does not have
to be plugged in to start water flow.
Water will flow into the ambient, cold and then the hot tank as well. Let
cooler tanks fill with the filtered water until full - about 1-hours for the
âROâ version, about 10-15 minutes for the âFâ version.
Observe the water level when full and see that water input to the tank
stops when it is full.
Figure. 7 Back view of the Cooler Water Connections Model G5