Use and Care Manual

16 | P a g e
Tank Flush
Flush tanks out by draining all water through the (1) drain
plug located on the back of the cooler and drain water through the
dispensing spigots. Fill and empty the tanks 3 times with the filtered
water, this ensures great tasting water. When the tank has filled again
with filtered water the cooler is ready to dispense water. You may
now turn on the Hot and Cold buttons on the back of the machine.
NOTE: You should always turn on the Hot and Cold elements
when they have water inside the tanks.
CAUTION. DO NOT TURN ON HOT OR COLD POWER CONTROLS
YET.
Remove the top cover of the cooler by removing 2 screws from back
of top cover. Pull the cover off, exposing the main tank. This model
uses a mechanical float valve to control flow to the tank. The unit does
not have to be plugged in to start water flow.
Water will flow into the ambient, cold and then the hot tank as well.
Let cooler tanks fill with the filtered water until full - about 1-hours
for the ‘RO’ version, about 10-15 minutes for the ‘F’ version.
Observe the water level when full, and see that water input to the tank
stops when it is full.
Figure. 7 Back view of the Cooler Water Connections Model G5