User Manual Bluetooth GPS Receiver BT-318
BT-318 at a glance
1. Introduction The BT-318 is a GPS receiver with Bluetooth interface and built- in active antenna for high sensitivity to tracking signal. Based on the SiRF star Ⅱe/LP low power chip set and supports all functions(SingleSat updates in reduced visibility, Superior urban canyon performance, FoliageLock for weak signal tracking, etc.). The BT-318 is well suited to system integration and users who use PDA, Smart phone, Tablet PC and Notebook PC with Bluetooth devices.
1.3 Power Switch Power on Power off 1.4 Power Jack The power jack lets you to connect either a DC car power charger (included) or AC power charger (included) to recharge the internal battery. You can either use the included two chargers or an iPAQ-compatible AC adapter. Please note that the adapter rating 5V, 1.2 A, positive pole center. 1.5 LED Function Bluetooth Status LED (Blue): Blinking (Slowly) ---- Not connected to any Bluetooth devices.
Notice: Hold the antenna connector while you plug the external antenna into the BT-318 or unplug the external antenna from the BT-318. Do not pull the cable line. 2. Usage 2.1. For PDA which built-in Bluetooth (Example: iPAQ 3870/3970) ? ? 1. Switch the BT-318 power on. 2. Please refer to the user manual of PDA to enable the Bluetooth of PDA connecting to the BT-318. Some PDAs may need the Bluetooth passkey, the passkey is “2003”. 3. Check the number of COM port used by Bluetooth.
2.3. For Notebook with Bluetooth device ? 1. Switch the BT-318 power on. 2. Please refer to the user manual of Bluetooth device to enable it connecting to the BT-318. Some Bluetooth devices may need the Bluetooth passkey, the passkey is “2003”. 3. Check the number of COM port used by Bluetooth.(Example COM 6). 4. Running the suitable mapping/navigation software and select the correct COM port & baud rate : 38400.
3. 1 System Specification Electrical Characteristics (Receiver) Frequency C/A Code Channels Accuracy Position Horizontal Velocity Time L1, 1575.42 MHz 1.023 MHz chip rate 12 channel all-in-view tracking 10 meters, 2D RMS 7 meters 2D RMS, WAAS corrected 1-5 meters DGPS corrected 0.1m/sec 1 micro-second synchronized to GPS time Datum Datum Default: WGS-84 Hot start Warm start Cold start Reacquisition 8 sec., average 38 sec., average 45 sec., average 0.1 sec.
FCC Notices This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2)This device must accept any interference received, including interference that may cause undesired operation . FCC RF Exposure requirements: This device and its antenna(s) must not be co- located or operation in conjunction with any other antenna or transmitter.
