User's Manual

TOC

7.5 READY? will display on the screen, push to GO! for a walk to calibrate.

7.6 Every 10 meters, the watch will show

current distance you have reach on

the screen.

7.7 When you achieve 400 meters, the

screen will show you CALI OK on the

screen and return to SETTINGS menu.

NOTE: The calibration process could be failed if GPS signal

lost more than 10 seconds. FAILED, PLEASE RETRY message

will pop up. Go through step 7.3 to 7.7 to complete the

calibration or push to leave.

8 About

8.1 VERSION

8.1.1 FIRMWARE

8.1.1.1 Here shows you the main firmware version. Ex. F-0GH-2X-1501152, 150115

is the date of FW released which is 2015 Jan 15

8.1.2 BLE FW

8.1.2.1 Here shows you the BLE firmware version. Ex. F-BLE-29-1503271, 150327

is the date of FW released which is 2015 Mar 27

NOTE: To check firmware information, please refer to Get More Information.

8.2 RESET

8.2.1 Allow you to reset the watch back to factory setting.

8.2.2 Default value in DON’T!! in case incidentally trigger reset.

8.2.3 Even OK! Was pushed, double confirmation will reserve a second chance.

Pair BLE Heart Rate Monitor (HRM) chest belt

NOTE: if you don’t have a BLE Heart Rate Monitor, you can skip this section.

Wear the Bluetooth Low Energy (BLE) heart rate monitor directly on your skin, just below

your breastplate. It should be snug enough to stay in place during your run.

1 Wrap the strap around your chest, and

connect the strap hook to the loop.

2 Connect the heart rate monitor module to the

strap.