Operation Manual

After this, the device switches to receiving, whereby the radio
wave number shows the quality of the reception: The more
radio waves are displayed, the better the reception.
As soon as the signal is received with sufficient strength, the relevant
data is shown in the display and the transmitter tower symbol is
constantly displayed. This process can take a few minutes.
Effective immediately, the weather station switches to receiving
several times a day and compares the displayed time with that from
the time signal transmitter.
If a week signal is received the base station will stop the receiving
process and the tower symbol will not be shown. The receiving proc-
ess will start again later.
In this case, the time continues to run normally, from the start time
of "00:00".
! First, check whether the location of the base station is suitable,
see page 16.
! You can restart the receiving process again manually, see
page 15, or
! Wait until the base station automatically switches to receiving
again later. Reception is usually better during the night.
! If reception is not possible at your location, you can set the time
and date manually, see next chapter.
Set time and date manually
1. Keep the MODE/SET. pressed until the year flashes in the dis-
play.
2. Using the +/ or -/ /ZONE buttons, set the year.
3. Press the MODE/SET. button to save the setting.
The month flashes in the display.
4. Using the +/ or -/ /ZONE buttons, set the month.