Owner's Manual

Page 9
Installation
INSTALL FLYWHEEL AND OPERATING HANDLE
Note: In order to transport the slicer, the ywheel
operating handle and the ywheel is packaged
uninstalled.
1. Move the carriage (5) as near to the operator as
possible (Figure 9-1).
2. Remove the taper pin (30) from the ywheel shaft
(31) (Figure 9-2).
3. Use a hammer to tap the taper pin (30) out of
ywheel shaft (31).
4. Install the shim (32) on the ywheel shaft (31).
5. Insert the ywheel (7) so that the ywheel operating
handle xing hole (x) is positioned above and to the
left of the axis of the taper pin hole (Figure 9-3).
5
4
Figure 9-1
31
32
30
Figure 9-2
31
7
32
30
7
x
6. Use a hammer to insert the taper pin (30) fully into
the hole of the ywheel shaft (31) (Figure 9-4).
Figure 9-3
30
30
7
Figure 9-4