Owner's Manual

Page 6

UNPACKING

1. Unpack the slicer immediately after receipt. If the machine is found to be damaged, save the packaging

material and contact the carrier within fteen (15) days of delivery and immediately contact your source of the

equipment. You have no recourse for damage after fteen (15) days of receipt.

2. With the slicer you should receive: four rubber feet, lubricating oil and an instruction manual. Contact Globe

or your local supplier if you did not receive all of these items.

TO AVOID SERIOUS PERSONAL INJURY

PROPERLY INSTALL SLICER IN ADEQUATE WORK AREA

• ALWAYS install equipment in a work area with adequate light and space.

• ONLY operate on a solid, level, nonskid surface that is nonammable.

• NEVER operate slicer with a damaged power cord or power plug.

• NEVER operate slicer with an extension cord.

• NEVER bypass, alter, or modify this equipment in any way from its original condition. Doing so can

create hazards and will void warranty.

• NEVER operate slicer without the knife cover, knife sharpener and knife ring guard securely installed.

• NEVER operate slicer without the warning labels attached to slicer (see page 4 for location) and the

Globe wall chart posted within view of operator.

INSTALLATION:

1. Read this manual thoroughly before installation and operation. DO NOT proceed with installation and

operation if you have any questions or if you do not understand anything in the manual. Contact your local

representative or Globe rst. Make sure to clean and sanitize your entire slicer before use. Refer to this

manual for cleaning and sanitizing guidelines.

2. Remove slicer from the corrugated box.

3. Make sure rubber feet are rmly tightened.

4. Loosen the food chute release knob that fastens the

food chute arm to the slicer base (Fig. 6-1).

NOTE: To protect the food chute during shipping, the

food chute is packaged uninstalled. The food

chute must be installed on the food chute arm.

5. Remove the food chute arm from the slicer base.

NOTE: The food chute release knob is not designed to

come completely off.

Installation

Food Chute

Release Knob

Food Chute

Arm

Figure 6-1