Owner's Manual

Page 9
DO NOT hold the food product with your hand. Never put you hand on or around food chute when
slicer is on. The food chute handle is the only part of the slicer you should touch while slicing.
5. Use food chute handle to manually push food chute back and forth. Food chute handle is the only part of
slicer you should touch while slicing. Do not catch slices with your hand. Let slices drop onto receiving area.
If a product needs to be adjusted during slicing, ALWAYS pull the food chute all the way towards
you. Turn off slicer, and close slicer table prior to adjusting the product and the end weight.
6. After the last slice stroke, pull food chute all the way towards you. Turn slicer off by pushing stop button.
Power indicator light will go out. Always turn slice thickness dial clockwise until it stops to close slicer table.
7. Now you can unload and load food product from food chute.
AUTOMATIC SLICER OPERATION (G12A only)
1. Make sure slicer is turned off (power indicator light not illuminated). Make sure auto engage lever is in
“Manual” position (Fig. 9-1) and food chute moves freely.
2. Pull food chute completely towards you and place food product onto food chute. Slice only boneless, unfrozen
product with slicer. Swing end weight into position to secure food product.
3. Rotate slice thickness dial counterclockwise to the desired setting. After slicing is complete, always turn slice
thickness dial clockwise until it stops to close slicer table.
4. Press start button. Power indicator light will illuminate (see page 4 for location).
BE ALERT. The next step will cause food chute to move automatically and it can move either
direction on start up.
NEVER attempt to adjust, load or unload food chute when slicer is in automatic operation.
NEVER put hand into chute arm opening on the right side of slicer.
5. To make food chute move automatically, pull up or raise auto engage lever into
“Automatic” position (Fig. 9-2).
6. To stop the automatic movement of food chute, push down or lower auto
engage lever to “Manual” position.
The knife is still rotating even though the chute has stopped.
7. To turn slicer completely off and stop knife, press stop button. If auto engage
lever has not already been returned to “Manual” position, push down or lower
lever to “Manual” position.
Operating Instructions
Figure 9-2
Figure 9-1