User's Manual

CONNECTING INSTRUCTIONS

Please keep these instructions

in a safe place. This is the only

duplicate of the unique QR

code for your product. You

may need it to reconnect the

product to your account or

transfer it to another account.

Don’t have a barcode?

Select "Don't have a barcode?" in the Alexa app and follow the in-app instructions on how to connect without a 2D barcode.

How to factory reset device

If you are struggling to set up your device, or if the device was already connected to a network, perform a factory reset by following the

instructions below:

1. Turn device ON for 10 seconds.

2. Turn device OFF and ON 5x. The light will ﬂash RED and then the light will change to WHITE. When the light changes to WHITE, this means the

factory reset mode was successful.

3. Scan the inner barcode (located on the instruction manual) and connect within 5 minutes. If you fail to connect within the 5-minute time frame,

turn device OFF and ON again once to re-enter pairing mode.

The light will ﬂash WHITE to indicate that the pairing was successful.

1. Download the Amazon Alexa app.

2. Power on your device.

Ensure your device has been installed correctly by following the instructions in the “Installation” section.

3. Scan barcode

• Launch the Amazon Alexa app.

• Select “Add a Device”.

• Select “Light”, locate Globe Electric and follow the in-app instructions on how to scan the 2D barcode.

Please note:

The device is automatically in pairing for 5 minutes once powered on. When you scan the barcode, the white light will ﬂash indicating the pairing is

successful. If within 5 minutes, it does not connect, turn the device OFF and ON again to re-enter pairing mode.