User's Guide
STATUS INDICATOR & CONTROLS
50586
INSTALLATION
Planning Installation
Compare all parts with the “Hardware Included” section.
If any part appears missing or damaged, do not install this product
and contact the Customer Service team at 1-888-543-1388 or e-mail to
info@globe-electric.com.
Tools Required
flat head screwdriver
phillips head
screwdriver
pliers
electrical tester
Hardware Included
NOTE: Hardware is not shown to actual size.
Status Indicator Light
On/Off Buttons
Green Blinking
Ready for setup/
Setup is in progress
Light is off
Light is on
Factory reset is complete
Device registered
and connected
No Network
Setup has timed out
Turn the light on/off
Factory reset
Enter pairing mode
Amber
Indicator is off
Red blinking
Solid Red
Short press power button (<1s)
Press and hold power button (>10s)
Red and Green blinking alternately
Solid Green for 3 seconds
WARNING:Improper wiring of any electrical device can cause fire, serious injury or
death. Always consult a qualified licensed electrician who will ensure the switch is
installed in accordance with local electrical codes and regulations. Before starting
installation, ensure the power is disconnected at the circuit breaker and test existing
switch with a voltage tester.
Caution
• Make sure that the power at the circuit breaker is off before wiring.
• Neutral wire is required. Confirm the wall box contains a neutral wire (typically white).
• The wire colours indicated in this manual are the common colors and may differ in
some homes. Please contact an electrician if you have different wire colours.
• Ensure the wire conductors are securely fastened to each wire.
• If missing, look for a bundle of white wires folded in the back of the switch box. Most
homes bult after 1978 have neutral wires.