Owner's Manual

Page 18
Troubleshooting Guide
PROBLEM CAUSE SOLUTION
Knife motor will not start Slicer not plugged in Plug in slicer.
Knife cover removed or not properly
installed
Install knife cover
Overload reset button tripped Press the reset button located
underneath the slicer
Green RUN indicator light ashing Knife cover removed or not properly
installed
Install knife cover
Ragged cuts-poor yield Dull knife Sharpen knife-make sure knife and
stones are clean
Chipped knife Sharpen or have new knife installed
Knife-slicer table gap too wide Call for service to adjust slicer table
Knife too small Have new knife installed
Part scraping knife Knife cover Lock knife cover release lever
Food chute Tighten or adjust food chute knob
Slicer table Call for service to adjust slicer table
Hard to sharpen Stones dirty, wet or clogged with
grease
Clean stones with warm water
and a brush. Allow stones to air
dry. Lubricate shafts with Globe oil
afterwards
Knife dirty Clean top and bottom of knife
Worn stones Have stones replaced
Stones not properly aligned Have sharpener adjusted
If problems persist and the assigned solution does not remedy the issue, please call our Service
Department at 866-260-0522.