User Manual

Page 10
Operating Instructions
Always STOP mixer BEFORE changing speeds. Failure to do so can damage the gears
or other parts and WILL void the warranty!
6. To change the speed while mixing:
a. Press the red STOP button, then wait for the agitator to come to a complete stop.
b. Change the speed by raising or lowering the speed control lever.
c. Press the green START button to restart the mixer.
NOTE: The SP62P, SP62P-4 and SP80PL will automatically shut off if the speed is changed while the mixer
is in operation.
NOTE: Mixer is equipped with motor overload protection. If mixer shuts off during operation, reduce
the batch size and:
a. SP25 and smaller models: Press the STOP button then press the overload reset button located
on the back of mixer.
b. Larger models: Wait two minutes then press the START button on the control panel.
NOTE: Second speed should never be used on 50% Absorption Ratio (AR) or lower with the exception of the
SP60. The SP60 requires a 50% reduction in batch size to mix in speed 2 with 50% AR doughs.
NOTE: Reduce batch size by 10% if using chilled our, water below 70°F, ice, or high gluten our.
7. When the ingredients have been thoroughly mixed, press the red STOP button to stop the mixer.
NOTE: If the timer was used, mixer will automatically stop when time has expired.
8. Lower bowl by pulling bowl lift lever forward and down to its resting position. For models SP40 and SP60,
rotate bowl lift wheel counterclockwise until it stops. For models SP62P, SP62P-4 and SP80PL, press the
down arrow (blue button) until the bowl stops.
9. Rotate bowl guard to the left so it is in the open position.
10. Remove the agitator from the planetary shaft by lifting it upwards, then rotating it counterclockwise until it is
unlocked. Lower the agitator and remove from the planetary shaft.
11. Push each bowl clamp backwards to unlock the bowl from the bowl cradle.
12. Lift up slightly on bowl so it clears pins on the bowl cradle.
Most batches are heavy. Always use two people to remove and transport the loaded
bowl after mixing is complete. A bowl truck is included with the SP60, SP62P and
SP80PL models and must be used to unload bowls containing more than 50 lbs.
per batch.