User Manual

Page 11
Operating Instructions
Before starting mixer: Always change speeds BEFORE starting mixer. Failure to do so
can damage the gears or other parts and WILL void the warranty!
USING MIXER’S DIGITAL CONTROLS AND TIMER
Read through this section and continue to page 13 for further operating instructions for use of the digital
controls on your mixer.
Mixer is equipped with a digital timer display, minutes and seconds buttons (to adjust the timed operations) and
Start / Stop buttons. Mixer can function in either timed operation or untimed operation.
Untimed Operation: For simple on/off mixing operation in an untimed operating mode, verify that bowl guard and
bowl lift are closed and locked into position.
- The display should read 00:00 to operate in untimed mode. Pressing the STOP button twice within one
second will reset the timer back to zero.
- Press START button to begin mixing. The display will scroll zeros across the display from left to right while
mixing. Press STOP button once the desired mixing is complete.
NOTE: Pressing STOP button twice within one second to reset the timer back to zero (00.00) is a feature only
available for models SP10-SP60.
Timed Operation: Timer on mixer can be set from 5 seconds to 60 minutes.
1. Set desired time. Minutes advance by one and seconds advance by ves before rolling over to zero.
NOTE: Press and continuously hold the up arrow buttons to the desired minutes and seconds. Press and
continuously hold, the button scrolls through the number cycles quickly. (To slow down the selection and to better
control the setting time, press the up or down arrow button do not continuously hold the button down).
2. Once the desired time is set, check that bowl guard and bowl lift are closed and locked into position,
and then press START.
3. Wait for the timed cycle to end or press STOP to pause the mixing cycle.
- Pressing the STOP button once stops the mixer and pauses the timer during operation.
- Pressing the STOP button once while the mixer is not in operation will reset the timer to the
last programed/set time.
- Double clicking the STOP button twice within one second while the mixer is not in operation
will reset the timer back to zero (00:00).
NOTE: Pressing STOP button twice within one second to reset the timer back to zero (00.00) is a feature only
available for models SP10-SP60.
NOTE: If a cycle is interrupted by the bowl guard being opened or by lowering the bowl lift lever, the mixer will
stop. After bowl guard and bowl lift are closed and locked into position, START button can be pressed to continue
the programmed time.
To add additional minutes or seconds to a mix time, STOP mixer and adjust the cycle mixing time.
4. Once a timed cycle ends, mixer will beep for 5 seconds and the digital display will ash for two
minutes (if not reset) indicating the timed cycle is complete.