User Manual

Page 12
Operating Instructions
HOW TO USE ATTACHMENT HUB
Never put your hand into the feed chute when using a mixer attachment.
Only operate the attachment hub in MANUAL mode.
DO NOT attempt to mix ingredients in bowl while using the hub.
Mixer must be OFF before installing attachment. Do NOT use attachments while mixing.
1. Loosen and remove attachment hub thumbscrew (Fig. 12-1).
2. Remove plastic cover from attachment hub (Fig. 12-1).
3. Lubricate attachment shaft with a food quality grease or mineral oil.
4. Insert attachment shaft into hub making sure to line up the alignment pin with
hub hole.
5. Tighten thumbscrew back into hub and securely tighten it.
6. Select the appropriate speed setting by lifting or lowering speed control lever.
Recommended Speed while using attachments:
Attachment: Recommended Speed:
Vegetable Slicer 1 or 2
Cheese Shredder/Grater 1 or 2
Meat Grinder 1 only
NOTE: Make sure bowl is up and bowl guard is closed. Mixer will not start if bowl and bowl guard are not in the
proper operating position.
7. Use the untimed operation described on the previous page to adjust timer.
8. Press the green START button located on the control panel.
Always STOP mixer BEFORE changing speeds! Failure to do so can damage the gears
or other parts and WILL void the warranty!
9. To change the speed while using mixer attachments:
a. Press red STOP button, then wait for the agitator to come to a complete stop.
b. Change speed by raising or lowering speed control lever.
c. Press green START button to restart mixer.
NOTE: The SP62P, SP62P-4 and SP80PL will automatically shut off if the speeds are changed while the mixer is in
operation.
Plastic Cover
Thumbscrew
Fig. 12-1