Installation Guide

RIGHT
SIDE BASE RAIL
LEFT
SIDE
BASE RAIL
FRONT
BASE RAIL
Diagram 2
CORNER
PANEL
(AT RIGHT
CORNER)
BACK
FRONT
FRONT
RIGHT
CORNER
2
3
1
FIT SCREWS
IN THIS ORDER
Step 3
Step 4
Fit one corner panel to the base rail outer edge in the
FRONT RIGHT CORNER as shown in Diagram 2.
IMPORTANT: WIDER face of panel
MUST FACE FRONT.
Secure with
three screws in
numerical order
as shown in
Diagram 2.
IMPORTANT:
Bend all four panels to a 90 angle by following the instructions
and diagrams to the right.
Corner panels are supplied bent to a 135° angle.
°
Lay the panel on a non-scratch
surface and carefully form the
angle to 90° by slowly working
along the panel and bending it
as you go. See Diagrams A - D.
IMPORTANT: DO NOT
OVER BEND PANEL.
IMPORTANT: Throughout these instructions fit screws
in the order shown (where applicable).
Diagram B
Diagram A
Repeat the procedure for the second corner panel
at the BACK RIGHT CORNER, ensuring WIDER face
of the panel faces the BACK. See Diagram 3.
Then fit one side mid-wall brace to the two
corner panels at the centre hole position,
and secure using a screw at each end of
the mid-wall brace. See Diagram 3.
IMPORTANT:
Holes at each end on the thin face
of the side mid-wall brace MUST
face upward.
Diagram 3
1
BACK
FRONT
SIDE
MID-WALL
BRACE
HOLES
ON THIN FACE
MUST FACE
UPWARD
WIDER FACE
MUST
FACE BACK
CORNER
PANEL
RIGHT
SIDE
BASE RAIL
BACK
BASE RAIL
2
3
5
2
3
1
FRONT
BASE RAIL
RIGHT
SIDE
BASE RAIL
FRONT
CORNER
PANEL
WITH WIDER FACE
AT FRONT
2
3
1
12
FORMING CORNER PANELS
FITTING CORNER PANELS
135°
90°
Diagram C
Diagram D
CORNER PANEL
END PROFILE
AS SUPPLIED
FOLDED TO REQUIRED ANGLE
4
E N G L I S H
© Globel Industries Pty Ltd
GI00045 September 30 2015