Installation Guide

FRONT
BACK
FRONT
BACK
Diagram 26A
Diagram 26
BACK
ROOF TRIM
FOR
6' AND 8'
WIDE SHEDS
FRONT
ROOF TRIM
NUTS AND BOLTS
IN THE 4 INNER HOLES
ONLY
4 ROOF CORNER CAPS
IN PLACE
TOP FACE
OF ROOF
SHEET
UNDERSIDE
OF TOP EDGE
OF ROOF TRIM
SEATED ON
TOP FACE
OF ROOF
SHEETS
Fit the four roof corner caps to the
left and right ends of both roof trims
and secure with nuts and bolts
as shown in Diagram 27.
Step 20
Step 19
Attach the roof trims to the front
and back edges of the roof sheets
as shown in Diagram 26,
by sliding the
bottom edge of the
roof trims under the
edge of the roof sheets
so the underside of
the top edge of the
roof trims are seated
on the top face of the
roof sheets.
Secure using one screw,
and nuts and bolts
ONLY IN HOLES AS SHOWN.
IMPORTANT:
FRONT ROOF TRIM - ALL SIZES:
Using a 3mm steel drill bit, drill a
pilot hole at the centre hole of the
FRONT roof trim and into the roof
sheet. Then fit a screw.
NOTE:
Roof corner cap fits OVER roof trim.
Washers are not required for this step.
22
ROOF TRIM
FIXED IN POSITION
Diagram 27
ROOF
CORNER
CAP
FITTING FRONT AND BACK
ROOF TRIMS
2
1
DRILL A 3mm
PILOT HOLE
THEN FIT SCREW
IMPORTANT:
Back roof trims for 6' and 8'
wide sheds require four nuts
and bolts, back roof trim
for 5' wide sheds require three
nuts and bolts.
See Diagram 26 and 26A.
BACK
ROOF TRIM
FOR 5' WIDE
SHEDS
NUTS AND BOLTS
IN THE 3 INNER HOLES
ONLY
E N G L I S H
© Globel Industries Pty Ltd
GI00045 September 30 2015