Installation Guide

Step 23
DOOR ADJUSTMENT
When both doors are closed, they should be
parallel at the centre. If not, adjust the position
of one of the bolts in the relevant door glide
to either raise or lower the edge of the door
to make it parallel with the edge of the
other door.
RECOMMENDATION
In most cases, only a small adjustment
is required by lifting or lowering the door
slightly, which can be achieved without
moving the bolt to another hole, but
by simply loosening the bolts in the
door glide and adjusting to suit, then
re-tightening.
Step 24
Fit the door fascia panel
to the front top rail, using
four screws as shown
in Diagram 32.
Diagram 32
DOOR
FASCIA PANEL
DOORS
HINT: Extra holes are provided to
align door if required. See Diagram 31.
BOTH
DOORS
SHOULD BE
PARALLEL
WHEN
CLOSED
Diagram 31
DOOR GLIDE
TOP
HOLES
BOTTOM
HOLES
24
E N G L I S H
© Globel Industries Pty Ltd
GI00045 September 30 2015