Installation Guide

Additional Notes
SLIDING DOORS:
SUGGESTION - Lubrication of Doors:
REPLACEMENT OF DOOR GLIDES:
SECURING & SEALING SHED BASE RAILS:
Spraying a silicone spray into the slot under the front top rail
and along the inside face of the internal front mid-wall brace,
will assist in a smoother and quieter operation of sliding doors.
Remove nuts and bolts from door glide(s) to be removed,
and slide in direction away from handle side
of door. Door glide will drop out from far end
of slot under front top rail.
Replace door glide by inserting into slot
under front top rail, slide into position and
secure with nuts and bolts. See diagram shown.
Refer to Pre-Assembly Section "Door Glides" (page 8)
and Steps 21 - 23 for full details on fitting door glides
and adjustment of doors.
We recommend the following procedure for
securing and sealing shed base rails
to concrete floor:
SECURE -
Secure shed base rails to concrete floor
using dyna-bolts as shown in diagram.
SEAL -
and apply silicone on inside of shed,
along the edge of the base rail
and to the floor.
Ensure floor is free of dust and debris
Dyna Bolt
6.5mm x 36mm
SILICONE
25
DOOR GLIDE.
NOTE:
CURVED SIDE
FACING FRONT FACE
OF GABLE ASSEMBLY
SLOT
SLIDE
BOLT & NUT
TOP RAIL
E N G L I S H
© Globel Industries Pty Ltd
GI00045 September 30 2015