User's Manual

Whenever the power is on, PS2 Dongle will search for the game controller within the effective range. As long
as the game controller is not recoded, it remains matched with the corresponding PS2 Dongle. In most cases,
the connection process will complete within 2 seconds.
(b) Manual Connection
Repeat the above similar procedures for manual connection.
(2) Turbo Operation
(a) Turbo ON/OFF
1. Press Turbo + a setting key (select one of the ╳ ○ □ △ L1 L2 R1 or R2 keys). The selected key will
enter the Turbo phase.
2. Press the same selected keys again to clear its Turbo function.
(b) Turbo LED Indication
Turbo LED light will turn on when Turbo button is pressed. Release the button and the light will go off.
Press the Turbo + Start buttons to change the Turbo speed.
(3) Sleep and Wake-up Mode
The game controller is designed with power-saving device to prolong the life span of the batteries.
1. To conserve power consumption, game controller will enter the sleeping mode after two minutes when it
is not connected.
2. Game controller will also enter the sleeping mode during the connection phase, after 5 minutes if neither
button nor stick handle is in used.
3. Press Turbo, Macro, Select, Start or Mode buttons to wake up the controller.
(4) Low Power Indicator
When battery voltage is lower than the preset voltage of 3.5V, Mode LED and Turbo/Macro LED lights will
flash simultaneously. Power of vibration motor will be cut off.
(5) MACRO Function
MACRO means the programmable function. Many fighting games require special tactics with a combination
of several different keys. Save the tactics utilizing the MACRO function, and just press the preset key to
perform the programmed fighting tactics while playing games.
(a) – To set MACRO
1. Press the MACRO button, and MACRO LED light turns on
2. Select and press one of the setting keys (L2, R2, Left Stick, Right Stick), MACRO LED light will flash
3. Press each sequence key to combine as MACRO function key. Each set of MACRO function key can
accommodate 15 keys. The setting is saved and quit automatically after 15 keys.
4. After the setting, press MACRO button and LED light turns off.
(b) – To cancel MACRO
1. Press MACRO button and the MACRO LED light turns on
2. Select and press one setting key (L2, R2, Left Stick or Right Stick). MACRO LED light will flash
3. Press MACRO button, and the LED light will turn off. The previous setting that is saved in the MACRO
function key will be cleared.
(c) – To set MACRO speed
Fast speed (0.03 second):
1. Press MACRO key → MACRO LED light turns on
2. Press “Up” button → MACRO LED light flashes
3. Press MACRO key
Slow speed (0.1 second):
1. Press MACRO key → MACRO LED light turns on
2. Press “Down” button → MACRO LED light flashes
3. Press MACRO key