User's Manual

AIR GIGARAY 70 GHz Technical Specification
Proprietary & Confidential Maribor, 25 June, 2020 Page 3 of 32
1. FOREWORD
IMPORTANT!!!!
Before you is a highly technical transmitting device intended to be used on
telecommunication towers. Please be aware of following notices and notes.
NOTICE:
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
NOTICE:
Changes or modifications made to this equipment not expressly approved by
(manufacturer name) may void the FCC authorization to operate this equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
NOTE: AIR BASE station INSTALLATION MANUAL covers the initial hardware installation,
system maintenance. The procedures described in this manual are intended to help
service technicians to install and do initial AIR base station start up. Users who perform
these tasks should be familiar with AIR hardware and cabling, wiring practices, and safety
precautions.
DANGER:
Do not intend to do unauthorized repairs. “Danger” do not do repairs when the units are
on power. Power off the unit and disconnect the power cable. Not following the
procedure permits the existence of a hazard that could result in death or serious bodily
injury if the safety instruction is not observed. Improper repair of the units may result in
safety hazards. Be sure to fasten screws securely with the right screwdriver. If a screw is
not fully fastened, it could come loose, creating a danger of a short circuit, which could
cause overheating, smoke or fire.
Radiofrequency Radiation Exposure:
This device is used on a fixed location in an area not accessible to the general public and
only accessible to highly skilled and trained engineers. The radiated output power of the
device is far below the FCC radio frequency exposure limits. Nevertheless, the device
should be used in such a manner that the potential for human contact during normal
operation is minimized. This equipment should be installed and operated with a minimum
distance of 2m between the radiator and your body.