User Guide

35／35
URC Unsolicited Result Code
USSD Unstructured Supplementary Service Data
WCDMA Wideband Code Division Multiple Access
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation. Changes or
modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
ＦＣＣ Ｓｔａｔｅｍｅｎｔ
NOTICE:
Please notice that if the FCC identification number is not visible when the module is installed inside
another device, then the outside of the device into which the module is installed must also display a
label referring to the enclosed module. This exterior label can use wording such as the following:
“Contains FCC ID:2AC88-GLMM20A01” any similar wording that expresses the same meaning may
be used.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with a minimum distance of 20cm between the
radiator & your body. This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
The module is limited to OEM installation ONLY.
The OEM integrator is responsible for ensuring that the end-user has no manual instruction
to remove or install module.
The module is limited to installation in mobile application.
A separate approval is required for all other operating configurations, including portable configurations
with respect to Part 2.1093 and difference antenna configurations.
There is requirement that the grantee provide guidance to the host manufacturer for compliance with
Part 15B requirements.
The finished product is required to comply with all applicable FCC equipment authorisations, regulati-
ons and qequipment. We will provide guidance to the host manufacturer for conpliance with the FCC
part 15B requiremnets.
The OEM integrator is responsible for ensuring that the end-user has no manual instructions to rem-
ove or install module.
The module is limited to installation in mobile or fixed application.
uCloudlink M3B Mini PCIe-C _Hardware Design Guide_V1.0