Use Instructions

18
IR
Compatible infrared cables
Insulin pumps - connected with infrared cables
Roche Accu-Chek
Smart Pix cable
Roche Accu-Chek
Smart Pix 2 cable
Smart Pix 2
Note! Connect the handset of your pump
with a micro USB cable to the Smart Pix 2.
1. Connect the Smart Pix 2 cable to Glooko Transmitter
and wait for the blue indicator on the Smart Pix 2
to start flashing slowly.
2. Connect the handset to the Smart Pix 2 with a
micro USB cable.
3. In the handset menu select Connect to PC and
press OK.
4. Ensure that the pump is within reach of the
handset.
5. The blue indicator on the Smart Pix 2 is on while
the data is being transmitted from the device to
the Smart Pix 2.
6. The blue indicator turns itself o and both
Smart Pix 2 and device emit a sound to signal that
the data is being transmitted from the
Smart Pix 2 to Glooko Transmitter. Do not disconnect
the Smart Pix 2 yet!
7. Wait for Glooko Transmitter to confirm the upload was
successful.
Roche
1. Connect the Smart Pix to Glooko Transmitter and
wait for the blue indicator on the Smart Pix to
start flashing slowly.
2. Put the pump in Data Transfer Mode (stop the pump
and enter the Data Transfer Menu).
3. Place the pump with its IR window towards the
Smart Pix. The blue indicator signals the data is
being transmitted to the Smart Pix.
4. Wait for the blue indicator to start flashing slowly
again or stop flashing altogether.
5. The data is now being transmitted from the
Smart Pix to Glooko Transmitter. Do not disconnect
the Smart Pix yet!
6. Wait for Glooko Transmitter to confirm the upload was
successful.
Smart Pix or Smart Pix 2
Note! Smart Pix soware version 3.02 or
higher is required when using Smart Pix.
Roche
Accu-Chek Aviva Insight
Accu-Chek Performa Insight
Roche
Accu-Chek Spirit Combo