User manual

5.2 Pump grip

Figure 9

The device types Pro 1300/1800 are equipped with an ergonomic handle which must be

mounted appropriately for left or right-hand use.

Mount the handle facing the left or right-hand side on the pump lever. Insert the handle

sections on the pump lever as shown.

NOTE!



You can choose between 2 insert positions which will shorten or extend the lever arm

of the pump lever according to the mounted handle position.

Insert the holding clip for the spraying lance as shown.

Then attach the second handle section and screw both handle sections to the pump lever as

shown.

5.3 Quick closure valve/hose/spraying lance

Figures 10 - 11

Push the hose up to the stop on the connection sleeve of the pump housing and screw

down tight with the coupling nut.

Push the hose up to the stop on the connection sleeve of the quick closure valve and

screw down with the coupling nut. Screw the spraying lance onto the quick closure valve.

Mount an extension if required (except type Hobby 1200).

6 Starting up

6.1 Filling the device

Figures 12 - 13

Remove the container cap and fill the device through the filling strainer. Close the

container with the container cap.

CAUTION



Note maximum fill level (see technical data), safety instructions and permissible

materials.



Check fill quantity.



Comply with the data of the spray product manufacturer!

6.2 Correctly fitting the shoulder strap / carrier system to the body

Figures 14 - 23

You can adjust your shoulder strap/carrier system (type-dependent) accurately to ensure

optimal load distribution and fatigue-free working. The device must be worn as close to the

body as possible and parallel to the spine.

Type Hobby 1200/1800: Padded shoulder strap

Fasten the shoulder straps as shown to the lower left and right outer strap buttons and

position the device on your back.

RZ_KRSG_EN.qxd:Text_EN 28.03.2013 18:29 Uhr Seite 22