User manual

Tighten the carrying straps over the shoulders by pulling the lower strap ends.

The carrying straps can be lengthened or shortened by adjusting the strap buckles.

Type Hobby 1800: includes lap belt

Before the strap lengths are adjusted, it is first necessary to clip on and tighten the lap

belt of this device.

Then tighten the carrying straps of the shoulder straps.

Type Pro 1300/1800: Carrier system with chest strap (Pro 1800 includes a lap belt)

Place the device on your back.

Clip on the chest strap and adjust height and width as shown.

Tighten the shoulder straps by pulling the lower strap ends as shown.

Adjust the carrying straps of the shoulder straps by pulling the upper strap buckles as

shown until the device lies parallel on the back. Adjustment is only possible when the

device is off the shoulders.

Type Pro 1800: includes lap belt

The lap belt must be clipped in and tightened on this device before the lower straps

ends are pulled to tighten the straps.

Tighten the shoulder straps by pulling the lower strap ends as shown.

6.3 Spraying

Figures 24 - 25

Move the pump lever maximum 3-4 times up and down. This fills the air vessel and the

spraying line with spray product and produces the operating pressure required for

spraying. Pressing the actuation lever down on the quick closure valve initiates the

spraying process. This can be interrupted immediately by releasing the actuation lever.

The spray pressure at the nozzle is influenced by the pumping process. The pressure can

be read off on the pressure gauge. The optimal spraying pressure is always dependent

on the nozzle used. It lies between 1.5 and 2.5 bar for the hollow cone nozzle mounted

at the factory.

The optimal distance between the nozzle and object for spraying is 40-50 cm.

CAUTION

Note wind direction! Do not spray into the wind. Ensure uniform wetting of the object

when spraying.

7 Shutting down

7.1 Emptying

Figures 26 - 27

Do not dispose of residues in the drains, but dilute 1:10 and spread over vegetation.

Clean the device and hose system thoroughly with water after each use (rinse several

times), actuating the pump and actuation lever on the quick closure valve several times

whilst doing so. Collect the discharge and apply as described above diluted 1:10 onto

vegetation. Leave the device to dry opened, hanging it up if possible with the opening

facing downwards.

RZ_KRSG_EN.qxd:Text_EN 08.02.2013 16:04 Uhr Seite 23